Roof Tech Talk

Search This Blog

Roof Report in 3 Parts!

February 03, 2014

Get link
Facebook
X
Pinterest
Email
Other Apps

Introduction:

Roof Conditions:

Patch & Repair:

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

The Diffence is in the Construction Details - Built-Up / Modified Bitumen

Roof perimeter and projection flashings must be installed correctly to ensure a long-lasting roof system. The following are considered basic flashing details. These have been pulled directly from the NRCA Roofing Manual. Installations vary by project. Embedded Edge Metal Construction Detail Embedded Edge Metal Construction Detail Installed Metal Parapet Cap Construction Detail Metal Parapet Cap Construction Detail Installed Raised Perimeter Edge with Metal Fascia Construction Detail Raised Perimeter Edge Metal Fascia Construction Detail Installed Surface Mounted Counterflashing Construction Detail Surface Mounted Counterflashing Construction Detail Installed Reglet Mounted Counterflashing Construction Detail Reglet Mounted Counterflashing Construction Detail Installed Expansion Joint Construction Detail Expansion Joint Constuction Detail Installed Raised Curb Construction Detail Raised Curb Const...

The Diffence is in the Construction Details - Single Ply

Roof perimeter and projection flashings must be installed correctly to ensure a long-lasting roof system. The following are considered basic flashing details. These have been pulled directly from the NRCA Roofing Manual. Installations vary by project. Embedded Edge Metal Construction Detail Embedded Edge Metal Construction Detail Installed Metal Parapet Cap Construction Detail Metal Parapet Cap Construction Detail Installed Raised Perimeter Edge With Metal Fascia Construction Detail Raised Perimeter Edge With Metal Fascia Construction Detail Installed Surface Mounted Counterflashing Construction Detail Surface Mounted Counterflashing Construction Detail Installed Reglet Mounted Counterflashing Construction Detail Reglet Mounted Counterflashing Construction Detail Installed Expansion Joint Construction Detail Expansion Joint Construction Detail Installed Raised Curb Construction Detail Raised Curb Constructio...

Shouldn't A Roofer Be Sealing Your Roof?

This is a photo of an improperly terminated roof projection. This electrician was contracted to add light fixtures to the building. Wiring could be run through the walls of a building, but is much easier and less labor intensive to install on the roof. After running the wires on the roof, the electrician cut the roof membrane and decking to run the wiring into the building. After encapsulating the wiring in pipes and boxes, the electrician sealed the area with a polyurethane-based insulating foam sealant. The conduit was then mechanically attached to a pipe block that was placed on the roof. Here are 3 things that are incorrect with this: 1. Any work performed on the roof by a contractor that does not specialize in roofing related work could void the warranty! 2. The polyurethane-based insulating foam sealant does not properly accommodate the movement of the roof membrane and the piping. The conduit is made of steel, and the roof is a Thermopla...

Powered by Blogger

Roof Report in 3 Parts!

Comments

Post a Comment